Canon 2080B001 XL H1S / XL H1A Instruction Manual - Page 151
Recording, Playback, Memory Card Operations, Others, About the LCD screen
UPC - 013803079685
View all Canon 2080B001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Recording Problem Cause Solution A vertical light bar appears on the screen. Bright light in a dark scene may cause a Record in Av mode with an aperture value 68 vertical light bar (smear) to appear. This is in the range F5.6-F8.0. not a malfunction. Viewfinder picture is blurred. Viewfinder is not adjusted. Adjust the viewfinder with the dioptric 23 adjustment lever. Audio is not recorded. The input channel selection switch is not set Set the INPUT SELECT switch to the correct 58 to the correct position. position. Microphone connected to the XLR terminal Set the switch to ON. 58 needs to be powered by the phantom power. Audio is recorded in a very low level. The REC LEVEL switch is set to M, and Adjust the audio level correctly. 59 recording level is set too low. Microphone attenuator is turned on. Set the FRONT MIC ATT. switch or the 59 switch to OFF. Playback Problem Cause Pressing the playback button does not start playback. Camcorder is turned off, or is not set to mode. Cassette is not loaded. Tape is running, but image will not appear Video heads are dirty. on the TV screen. You attempted to play back or dub a copyright protected tape. The video output cable is not connected correctly. While playing back a tape recorded in HDV Video heads are dirty. standard there are brief stops in the playback picture. Memory Card Operations Solution Set the camcorder to mode. 114 Load a cassette. 31 Clean the video heads. 148 Stop playback/dubbing. - Verify that the video cable is connected - properly. Clean the video heads with a dry cleaning 148 cassette. Problem Memory card cannot be inserted. Memory card cannot be recorded. Memory card cannot be played back. Image cannot be erased. flashes red. Others Cause Solution Memory card was not facing the correct direction. Turn the memory card over and try inserting it again. 32 No memory card. Insert a memory card. 32 Memory card is full. Replace the memory card or erase images. 129 Memory card is not initialized. Initialize the memory card. 131 The folder and file numbers have reached their maximum value. Set [FILE NOS.] to [RESET] and insert a new memory card. 120 The dial or / (card/tape) switch are not set to the correct position. Set the dial to VCR/PLAY and the / (card/tape) switch to . 127 Image is protected. Cancel the protection. On an SDHC or SD memory card, the write- Change the position of the write-protect 148 protect switch is set to the locked position. switch on the memory card to unlock it. Card error occurred. Turn off the camcorder. Remove and reinsert the memory card. Initialize the 131 memory card if flashing persists. Lenses with built-in image stabilizer: Detected air bubbles inside the lens. Sometimes air bubbles may form inside the lens in airplanes or on high mountains. This is - not a malfunction. The air bubbles disappear in about 1 week. About the LCD screen The LCD screen is produced with extremely high-precision manufacturing techniques, with more than 99.99% of the pixels operating to specification. Less than 0.01% of the pixels may occasionally misfire or appear as black, red, green or blue dots. This has no effect on the recorded image and does not constitute a malfunction. Additional Information 151