Canon DC330 DC330 Instruction Manual - Page 82

- Finalize the disc using the camcorder ( 49). - DVD-RW discs in VR mode can only be played back with VR mode-compatible DVD players. Refer to the instruction manual of your DVD device. Cannot edit my recordings or add recordings to the disc with the DVD device. - It may not be possible to edit or add recordings with an external DVD recorder on a disc recorded with this camcorder. Memory Card Operation Memory card cannot be inserted. - Memory card is not facing the correct direction. Turn the memory card over and reinsert it ( 29). Cannot record on the memory card. - Memory card is full. Erase still images ( 56) to free some space or replace the memory card. - Memory card was not initialized. Initialize the memory card ( 60). - The folder and file numbers have reached their maximum value. Set [FILE NOS.] to [RESET] ( 77) and insert a new memory card. - The write-protect switch on an SD or SDHC memory card is set to prevent accidental erasure. Change the position of the write-protect switch. Memory card cannot be played back. - Set the camcorder to mode ( 54). Image cannot be erased. - Image is protected. Cancel the protection ( 59). - The write-protect switch on an SD or SDHC memory card is set to prevent accidental erasure. Change the position of the write-protect switch. appears in red. - A memory card error occurred. Turn off the camcorder. Remove and reinsert the memory card. Initialize the memory card ( 60) if the icon still appears in red. Printing The printer is not operating even though the camcorder and printer are correctly connected. - Disconnect the USB cable and turn off the camcorder and the printer. After a short while, turn them on again, set the camcorder to mode and restore the connection. List of Messages List of Messages (in alphabetical order) CANNOT ENTER THE STANDBY MODE NOW - The camcorder cannot enter the Quick Start standby mode ( 34) while the disc is being recognized after it was inserted or if the remaining battery charge is too low. CANNOT PLAY BACK - The disc is dirty or you attempted to play back a disc type not supported by this camcorder (not DVD-R/RW) or a disc that is dirty or scratched. - This message can also appear if condensation has formed. Wait until the camcorder dries completely before resuming use ( 90). CANNOT READ THE DISC CHECK THE DISC - Disc could not be read. Try cleaning it or replace the disc ( 87). - This message can also appear if the camcorder has exceeded its operational temperature. Turn off the camcorder and let it cool down before resuming use. - This message can also appear if condensation has formed. Wait until the camcorder dries completely before resuming use ( 90). - The disc may not be loaded correctly. Try removing the disc and reinserting it ( 27). 82 • Additional Information