Canon EOS Elan II EOS ELAN II Instruction Manual - Page 86
Troubleshooting, Guide
UPC - 082966123436
View all Canon EOS Elan II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Troubleshooting Guide If there is a problem, follow the solutions in this Troubleshooting Guide. If the problem still persists, take your camera to your nearest Canon Service Center. Canon Service Centers are listed on the back of this Instructions booklet. Problem Probable Cause Solution Page No. 1. Nothing is displayed on the The battery is exhausted. LCD panel. Replace the battery with a new 17 one. The battery has been installed Install the battery correctly. 17 incorrectly. 2. The shutter does not release. The film has not been loaded Load the film correctly. correctly. (The frame No. is not 21 displayed on the LCD panel.) Rewound film is still in the Take,out the film cartridge and camera. (The frame counter on load a new roll of film. 23 the LCD panel displays = .) Focus has not been achieved. Press the shutter button (The in-focus indicator in the halfway until focus is achieved. viewfinder is blinking.) If focus still cannot be achieved, set the focus mode 39 switch on the lens to M and focus manually. 3. The photograph is out of The focus mode switch on the Set the focus mode switch on focus. lens has been set to M the lens to AF (Autofocus). 19 (Manual). The shutter speed is too slow Press the shutter button to prevent blur caused by without shaking the camera or 20 camera shake. use a faster shutter speed. 4. Only CO blinks on the The battery level is very low. Replace the battery with a new LCD panel. one and check that the battery level is displayed on the LCD 18 panel. The camera is not operating properly. Press the shutter button halfway and check that the battery level is displayed on the LCD panel. 18 Back cover 86