Canon LV-7215 lv7210_series_exp_cmd.pdf - Page 47
CR_PTIMERCOMMAND, 12.5 CR_TEMPWARNCOMMAND, Ex. When S_W_S[CR] means that sensor 1 is safety - case
View all Canon LV-7215 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210 9.12.4 CR_PTIMERCOMMAND COMMAND "CR_PTIMER" [CR] Details Get Presentation Timer status Acceptable "000_%a" [CR] Response "ON"------- Presentation timer is active %a "STOP"--- Presentation timer is pause "OFF"----- Presentation timer is inactive Unacceptable "?" [CR] 9.12.5 CR_TEMPWARNCOMMAND COMMAND "CR_TEMPWARN" [CR] Details Get if the sensors are exceeding or approaching critical temperature. When some sensors are installed inside the projector, get each sensor's temperature. Acceptable "000_%a_%b_%c" [CR] Response %a...temperature sensor 1 status %b...temperature sensor 2 status %c...temperature sensor 3 status "W"--- Exceeding critical temperature(Warning) "S"--- Sensor temperature is safe. %a "N"--- Not relate to the temperature %b Ex. When "S_W_S"[CR] means that sensor 1 is safety %c temperature, sensor 2 is exceeding critical temperature, and sensor 3 is safety temperature. Note)Depends on projector Models, when the temperature difference between sensor 1 and sensor 2 is over the specified temperature, the sensor may show "W". In this case, sensor 3 shows that the temperature difference is "W", "S", or "N". Unacceptable "?" [CR] 9.12.6 CR_TEMPFAILCOMMAND COMMAND "CR_TEMPFAIL" [CR] Details Get the temperature inside a projector. When some temperature sensors are installed in the projector, it is possible to know the temperature all at once. Acceptable "000_%a_%b_%c" [CR] Response %a=Temperature, sensor 1 %b=Temperature, sensor 2 %c=Temperature, sensor 3 (Ex.) "_31.5F" [CR] _means a space. When the temperature sinks to -, the first %a %b %c character "-"like "-05.5F" [CR]. Last character indicates the sensor's status. Exceeding critical temperature ="F" Sensor temperature is safe ="S" Not relate to the temperature="N" "_31.5F"indicates 31.5 degrees and safety temperature. When the temperature is safe, the data will be " 00.0S". Every time the projector is reset, " 00.0S"is set. In short, previous data is deleted. Unacceptable "?" [CR] Page 47