Canon LV-7225 Basic_Serial_Command_Codes - Page 12

Basic Serial Command Functional Specification Page 11 of 19 6.31. Computer 2 SCART Command Command "C26" [CR] Detail Select SCART RGB input for Computer 2. However, when Computer 2 terminal is set to Monitor Out, acceptable command is returned, but does not execute command. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.32. Image (Toggle) Command Command "C27" [CR] Detail Switch Image setting status. This command works the same as the Remote control's "IMAGE" button. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.33. On Start Setting Command Command "C28" [CR] Detail Set Power On Start status This setting status is stored in EEPROM, hold even if turning Off and On. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.34. On Start Cancellation Command Command "C29" [CR] Detail Cancel Power On Start status. This setting status is stored in EEPROM, hold even if turning Off and On. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.35. Power Management Ready Command Command "C2A" [CR] Detail Set Power Management to Ready mode. This setting status is stored in EEPROM, hold even if turning Off and On. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.36. Power Management Off Command Command "C2B" [CR] Detail Set Power Management to Off mode. This setting status is stored in EEPROM, hold even if turning Off and On. Response Acceptable [ACK] [CR] Unacceptable "?" [CR] 6.37. Power Management Shut Down Command Command "C2E" [CR] Detail Set Power Management to Shut Down mode. This setting status is stored in EEPROM, hold even if turning Off and On. Response Acceptable [ACK] [CR] Unacceptable "?" [CR]