Canon LV-7375 Projector Monitoring Software Ver.1.0.0 User's Manual - Page 6

To configure a broadcast address, select the [Broadcast] tab and click the [New], To specify an IP

Get Canon LV-7375 PDF manuals and user guides View all Canon LV-7375 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

CHAPTER 1 • Introduction 33 To configure a broadcast address, select the [Broadcast] tab and click the [New] button. [Specify broadcast discovery settings] dialog will display. Note -- As default, broadcast settings configured on the network card of the administrative computer will display in the discovery range list. 44 Complete the dialog with necessary information and click the [OK] button. Category Broadcast address Community Name Timeout Password (SNMP V3 only) Enable encryption (SNMP V3 only) Description Enter a broadcast address of the network to discover in "XXX. XXX.XXX.XXX" form. Enter a community name within 15 one-byte alphanumeric characters and symbols. Enter a number of seconds to time out, from 1 to 9. Enter a password within 8 to 15 one-byte alphanumeric characters and symbols. Place a checkmark if encrypted. Remove a checkmark if not. 55 To specify an IP address range, select the [IP address ranges] tab and click the [New] button. [Specify IP address range] dialog will display. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
6
CHAPTER 1 • Introduction
To configure a broadcast address, select the [Broadcast] tab and click the [New]
3
button.
[Specify broadcast discovery settings] dialog will display.
Note
As default, broadcast settings configured on the network card of the
-
administrative computer will display in the discovery range list.
Complete the dialog with necessary information and click the [OK] button.
4
Category
Description
Broadcast address
Enter a broadcast address of the network to discover in "XXX.
XXX.XXX.XXX" form.
Community Name
Enter a community name within 15 one-byte alphanumeric
characters and symbols.
Timeout
Enter a number of seconds to time out, from 1 to 9.
Password
(SNMP V3 only)
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
Enable encryption
(SNMP V3 only)
Place a checkmark if encrypted. Remove a checkmark if not.
To specify an IP address range, select the [IP address ranges] tab and click
5
the [New] button.
[Specify IP address range] dialog will display.