Canon PIXMA MG6120 Network Setup Troubleshooting - Page 10

ENGLISH Check 2 Is the machine connected to a network? • To confirm the connection status, use the { or } button to display Setup on the HOME screen and touch the right FUNCTION button, then using the { } [ ] and OK buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list or LAN setting list. Make sure that Connection is set to Active. Check 4 When obtaining an IP address automatically, make sure that the DHCP function of the network device (router, access point, etc.) is active. • For details on how to check settings of the network device, refer to the manual supplied with the network device or contact its manufacturer. If the machine is not connected to a network, perform setup again by following the procedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printed manual: Getting Started. Check 3 Is the IP filtering feature enabled on the network device (router, access point, etc.)? • For details on how to check settings of the network device, refer to the manual supplied with the network device or contact its manufacturer. Activate the DHCP function of the network device, then click Back (A). • For details on how to change settings of the network device, refer to the manual supplied with the network device or contact its manufacturer. Check 5 (* Wireless connection only) Is the privacy separator feature enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Set the network device to accept the IP address of the machine. • For details on how to change settings of the network device, refer to the manual supplied with the network device or contact its manufacturer. • To check the IP address of the machine, use the { or } button to display Setup on the HOME screen and touch the right FUNCTION button, then using the { } [ ] and OK buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list or LAN setting list to check IP address. Disable the privacy separator feature. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Glossary • IP address A numerical identification assigned to each computer or network device connected to a network. • IP address filtering A function to allow or restrict access from network devices with specified IP addresses. • DHCP function A function to automatically assign required information (IP address, etc.) to computers, printers or other devices connected to the network. • Privacy separator feature A function to prevent communication between multiple wireless devices (such as computers and printers) connected to an access point.