Canon PIXMA MX410 Network Setup Troubleshooting - Page 5
Check, Set Printer IP Address - mac
View all Canon PIXMA MX410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Set the access point to accept the MAC address of the machine. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • To check the MAC address of the machine, print the Network Configuration Page, then check MAC Address. To print the Network Configuration Page, select Device settings using the Menu button, then select LAN settings > Print LAN details using the [, ] and OK buttons. Check 4 Is the firewall function of your security software active? A message may appear on the computer monitor warning that Canon software is attempting to access the network. If the warning message appears, set the security software to always allow access. Glossary • Network Key A password required to set to prevent unauthorized access to communication. • DHCP function A function to automatically assign required information (IP address, etc.) to computers, printers or other devices connected to the network. • IP address A numerical identification assigned to each computer or network device connected to a network. • MAC address A unique number assigned to each network device. • MAC address filtering A function to block access from unauthorized wireless devices by saving the MAC addresses of specific wireless devices (computers, printers, etc.) to the access point beforehand. • Firewall A system to use computers connected to the Internet and corporate networks safely. It protects computers and corporate networks against unauthorized access, or restricts unauthorized access to corporate networks and the Internet. Set Printer IP Address Screen is Displayed Check Check 1 Make sure that you follow "Connection Checklist" on B page 11, then click Connect (A). C D Check 2 Turn off the access point, turn it back on, then click Connect (A). A Check 3 When obtaining an IP address automatically, make sure that the DHCP function of the access point is active. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Enable the DHCP function of the access point, select Get IP address automatically (B), then click Connect (A). • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Check 4 If the problem is not solved even after following Check 1 to 3, follow the procedure below to specify the IP address. 1 Select Use next IP address (C). 2 Enter the value you want to specify for each of IP Address, Subnet Mask, and Default Gateway or Router (D). 3 Click Connect (A).