Canon REALiS LCOS WUX6000 WUX6000 Command List - Page 5
Communication Specifications
![]() |
View all Canon REALiS LCOS WUX6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
WUX6000 User Commands 2. Communication Specifications Communication Specifications The projector can be controlled via RS-232C or LAN cable connection. PC - Projector connection configuration LAN PORT LAN PORT PC Network connection COM PORT PC SERVICE PORT RS232C crossover cable PROJECTOR Item Connection system Connection signal line Connection cable RS-232C connection Specifications PC and projector connected on a "1:1" basis 3-line connection of SD, RD, and SG 9-pin RS-232C cable (crossover) Item Connection system Connection signal line Connection cable LAN LAN connection Specifications TCP / IP connection Straight when connecting via network LAN cable 1000BASE-T 100BASE-TX 10BASE-T ૹS৴enσd Dʔaλta SD Rडec৴eivσe ʔDaλta RD SD Sૹen৴dσDaʔtaλ RD Rडe৴ceiσveʔDaλta Si৴gn߸al ༻Grઃouஔnd SG SG S৴ig߸na༻l Gઃroஔund * Signal lines other than the three SD, RD, and SG lines are not used in the projector. * Loop back its own signals on the PC side as necessary. * To use the LAN connection, the network function on the projector must be turned on. In addition, to allow network communication between the PC and projector, connect cables between the devices, and set the IP addresses, subnet masks, and other network parameters.
![](/manual_guide/products/canon-realis-lcos-wux6000-wux6000-command-list-438126e/5.png)