Canon WFT-E5A WFT-E5 Instruction Manual - Page 92
Connecting GPS Devices with a USB Cable
UPC - 013803119282
View all Canon WFT-E5A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Connecting GPS Devices with a USB Cable Turn off the GPS device and camera before connecting them. When connecting GPS devices, be sure to use the USB cable provided with the camera. The transmitter USB port is not hot-pluggable. USB cables cannot be connected or disconnected at any time. Follow the instructions in this section when connecting or disconnecting USB cables. 1 Plug the GPS device into the USB port. Open the port cover and connect the GPS device. Do not connect GPS device via a USB hub. Do not turn the GPS device on until step 5. 2 In [WFT settings], select [USB device connec.]. If you will not use a wireless or wired LAN at the same time as the GPS device, set [Communication mode] to [Disconnect]. 3 Select [GPS]. 4 Select [Connect]. When replacing the transmitter's battery, be sure to first set the camera's power switch to before opening the transmitter's battery compartment cover. If the transmitter's battery compartment cover is opened without setting the camera's power switch to , the connection operation for the GPS device will have to be performed again. 92