Canon imagePROGRAF iPF6400 Setup Guide - Page 2

Order to read through the setup guides Only purchased printer: "This Setup Guide" only Purchased printer and printer stand at the same time: "ST-28 Printer Stand Setup Guide" → "This Setup Guide" Purchased printer, printer stand, and spectrophotometer unit at the same time: "ST-28 Printer Stand Setup Guide" → "SU-21 Spectrophotometer Unit Setup Guide" → "This Setup Guide" Preparations Prepare the printer for use by installing it and connecting the power cord. 1 Install the printer. You can use the following two methods for installing the printer. • Install with the optional stand • Install without a stand on a table Assemble the stand and install the printer referring to the Printer Stand Setup Guide included with the stand. If you are using the spectrophotometer unit, install the spectrophotometer unit and printer by referring to the "SU-21 Spectrophotometer Unit Setup Guide". After installation, proceed to step 4. Proceed to step 2. • The stand is a standard accessory MEMO in some locations. 2 Remove the printer from the box and remove the packing materials from the top of the printer. 3 At least three people are needed to lift the printer by its carrying handles (a), located under its right and left ends, and to place it on a table or other flat surface. The printer weighs 54 kg and requires at least three people to lift it by its carrying handles (a) under its right and left ends. 4 Remove all the orange tape from the roll feed unit (a). Remove the roll holder (b) from the roll feed unit (a) and remove the protective materials and all the orange tape on the two holder stoppers (c). b ac 5 Remove the orange tape on the top cover (a) and the ejection guide (b) and all the packing materials. After removing the orange tape and packing material from inside the ejection guide (b), reattach it. a a a 6 Lift the belt stopper (b) from the carriage shaft (a) and pull it towards you to remove it. b a • The belt stopper is used when MEMO transporting the printer. Keep the belt stopper after removing it, in case the printer needs to be moved again. b • If the Spectrophotometer Unit MEMO (optional) is attached, the Ejection Guide (b) does not need to be reattached. 7 Close the top cover. 8 Plug the power cord into the power supply connector on the back of the printer and plug the other end into an electric outlet. 2