Chicco 00060796430070 User Guide - Page 11
To Install Insert in Carrier
UPC - 049796603385
View all Chicco 00060796430070 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
CANOPY To Adjust Canopy, grab bow on both a sides and rotate. Detach fastener tabs when rotating toward front of carrier. a To Remove Canopy Fabric, pull fabric away from Canopy Mount to expose button. Press button on canopy mount to release end of bow. Slide canopy fabric off bow and detach canopy from rear of pad. Release bow from canopy b mount on opposite side of carrier if using carrier without canopy. To replace canopy, reverse previous steps. To extend/retract visor b To retract the visor, gently push it downward and allow it to pop up under the canopy. The canopy must be extended before attempting to retract c the visor. c To extend the visor, gently pull it downward from underneath the canopy and allow it to pop into its extended position. 20 NEWBORN INSERT Use Newborn Insert to provide additional support and ensure a secure harness fit for smaller 1 infants. The harness height may have to be changed to fit your child. Before using insert, read the instructions on "Changing Harness Height" and "Securing Child in Carrier" 2 To Install Insert in Carrier 1 Pull End of Buckle through center slot in insert. 2 Pull Both Harness Straps over and around side panels. Push insert firmly into bottom of carrier. 3 Top of insert should always be BELOW the lower harness slots. 3 When properly installed, the Newborn Insert and harness should look like drawing. ONLY USE Insert with infants who weigh between 4 and 11 lbs. NEVER USE Insert if child weighs more than 11 lbs! 21