Chicco 00060796430070 User Guide - Page 20

INSTALLATION IN AIRCRAFT This Child Restraint is certified for use in commercial aircraft. Be sure to contact your airline prior to travel, to discuss their Child Restraint policy. 1 Position Carrier rear facing in aircraft seat, with child properly secured in Carrier. 2 2 Route Aircraft Lap Belt under both Belt Guides, and fasten the aircraft belt. 3 Tighten Aircraft Lap Belt while pushing Carrier firmly into aircraft seat. 3 4 A tightly rolled airline blanket may be used under the front edge of the b Carrier if needed to adjust angle of the Carrier. Angle is correct when level line on Carrier is level with floor. 4 Check Installation: a Level Line on Carrier MUST be LEVEL with floor. b Aircraft belt MUST be TIGHT. c Carrier MUST be STABLE a and secure. 38 CLEANING & MAINTENANCE Fabrics may be spot-cleaned with mild soap and water, or machine washed in cold water on delicate cycle using mild detergent. Hang to dry. DO NOT USE BLEACH. Removing the Seat Pad Remove Harness Straps from 1 Harness Slots as described in "Changing Harness Height." 1 Unhook elastic band attached around handle pivots, and disconnect chest clip and buckle. 2 2 Carefully pull seat pad from under Adjuster Cover. ADJUSTER COVER MUST REMAIN IN PLACE. Guide harness assembly through slots in bottom of seat pad, while removing from Carrier. Installing the Seat Pad Reverse the removal instructions to reinstall the Seat Pad. Carefully follow instructions in "Changing Harness Height" to ensure the harness is properly routed and adjusted. NEVER use Carrier without the Seat Pad. 39