Cisco WRP400-G1 Administration Guide - Page 74
Regional Distinctive Ring/CWT Pattern Names - specs
UPC - 745883580958
View all Cisco WRP400-G1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Advanced Voice Fields Regional page A EXT IP EXT RTP Port Min NAT Keep Alive Intvl External IP address to substitute for the actual IP address of the WRP400 in all outgoing SIP messages. If 0.0.0.0 is specified, no IP address substitution is performed. If this parameter is specified, the WRP400 assumes this IP address when generating SIP messages and SDP (if NAT Mapping is enabled for that line). However, the results of STUN and VIA received parameter processing, if available, supersede this statically configured value. NOTE: This option requires that you have (1) a static IP address from your Internet Service Provider and (2) an edge device with a symmetric NAT mechanism. If the WRP400 is the edge device, the second requirement is met. The default is 0.0.0.0. External port mapping number of the RTP Port Min. number. If this value is not zero, the RTP port number in all outgoing SIP messages is substituted for the corresponding port value in the external RTP port range. The default is 0. Interval between NAT-mapping keep alive messages. The default is 15. Regional page You can use the Voice tab > Regional page to localize your system with the appropriate regional settings. This page includes the following sections: • "Call Progress Tones section" section on page 73 • "Distinctive Ring Patterns section" section on page 75 • "Distinctive Call Waiting Tone Patterns section" section on page 76 • "Distinctive Ring/CWT Pattern Names section" section on page 77 • "Ring and Call Waiting Tone Spec section" section on page 78 • "Control Timer Values (sec) section" section on page 78 • "Vertical Service Activation Codes section" section on page 80 Cisco Small Business WRP400 Administration Guide 72