Cisco WS-C6509-V-E User Guide - Page 299
Trap Generation Area, SNMP Trap Area
View all Cisco WS-C6509-V-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 299 highlights
Chapter 6 Logical Object Dialog Boxes C6576M NE Config/Mgmt Dialog Box Trap Generation Area The Trap Generation area of the C6576M Network Element dialog box provides the following information: • SNMP Trap Status-Indicates the level at which SNMP traps are enabled. The level is one of these values: - disabled - layer2Only - layer3Only - layer2And3 • Enable button-Enables all SNMP trap generation from the switch or router. • Disable button-Disables all SNMP trap generation from the switch or router. SNMP Trap Area The SNMP Trap area of the C6576M Network Element dialog box provides the following information: • Trap Client IP Table-IP address table to which SNMP traps generated by the switch or router are sent. - Trap Client IP-The IP address to which SNMP traps are sent. - Client Community-The community string used within the SNMP trap. - SNMP Version-Version of the SNMP protocol used by CEMF to communicate with the managed device. This field has the following values: • snmpv1 • snmpv2c - Notification Layer - Indicates the level at which the SNMP trap client is defined. The level is one of these values: • layer2Only • layer3Only • layer2And3 Note The IP address of the CEMF server host should be in this list at all times. If it is not, then CEMF will not receive any traps from the switch or router, which might result in an event being reported in an untimely fashion or an event being missed. • Configure button-Displays the subdialog box, shown in Figure 6-6, for modifying the Trap Client list. - SNMP Trap Client Address-The IP address to which SNMP traps are sent. - SNMP Trap Client Community String-The community string used within the SNMP trap. - Add Client button-Adds a client to the client list. - Remove Client button-Removes the client from the client list. Cisco 6500/7600 Series Manager User Guide 6-9