Cobra CXT 1035R FLT CXT 1035R FLT - Page 4
Using Your Radio
View all Cobra CXT 1035R FLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Operation Using Your Radio Introduction Operation Customer Assistance Warranty For charging microTALK radio(s) in desktop charger: 1. Insert radio(s) into desktop charger as shown. 2. Insert the micro-USB cable into jack on back of charger. Note: charger should be installed near the equipment and easily accessible. RX 3. P lug the charging cable into a power source. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily Battery Low • Battery Low W hen battery power is low, the final bar in the Battery Low icon will blink and an audible tone will sound twice Vox before the radio shuts off. Your batteries should be HI MED LO WX replaced or recharged, if using rechargeable batteries. TW DCS Scan CTCSS Mem The radio's LCD display will show a blinking charging staus indicator while charging. accessible. If charging light is not on, check position of radio. Radio should be upright. The charge indicator light will stay on until the charging is complete. Auto Battery Save • BURP PoBwatteerySSaavveerMode If there are no transmissions within 10 seconds, the radio will automatically switch to Battery Save mode and the Power Saver icon will flash in the Quick Start 1. Press and hold the Mode/Power button to turn on your radio. 2. Press the Channel Up or Channel Down display. This will not affect the radio's ability to receive incoming transmissions. Communicating with Another Person • Talk Button 1. Press and hold the Talk button. button to select a channel. 2. With the microphone about two inches (5 cm) from MEM ESC TRI WATCH SCAN Both radios must be tuned to the same channel/privacy code to communicate. 3. Press and hold the Talk button while speaking into the microphone. Two Inches (5 cm) from Mouth your mouth, speak in a normal voice. 3. Release the Talk button when you are finished talking and listen for a response. You cannot receive incoming calls while pressing the Talk button. 4. When finished talking, release the Talk button and listen for a response. Both radios must be tuned to the same channel/privacy code to communicate. CHANNEL CHANNEL Turning on Your microTALK® Radio • Mode/Power P ress and hold the Mode/Power button until you hear CALL a series of audible tones indicating the radio is on. MODE Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always in Standby mode except when the Talk, Call or Mode/Power buttons are pressed. MEM ESC To Select TRI WATCH SCAN a Channel • Channel Button With the radio on, select any of the 22 channels by pressing the Channel Up or Channel Down button. Both radios must be tuned to the same channel to communicate. CALL RX Vox MODCE hanneHl INMuEmD bLOerWX Channels 1 through 7 are shared with FRS/ GMRS. TW DCS ScCanhannels 8 through 14 are FRS only. Channels 15 CTCSS Memthrough 22 are GMRS only. BURP Power Saver See page 20 for FRS/GMRS frequency allocations and compatibility charts. VOLUME VOLUME 2 Nothing Comes Close to a Cobra® 3