Cobra CXT 1035R FLT CXT 1035R FLT - Page 6

VOLUME ESC WATCH SCAN MEM TRI ESC OpeWrAaTtCioHn SCAN Using Your Radio Scrolling Through the Mode Function • By scrolling through the Mode function, you will be able to CHANNEL select or turn on preferred features of your microTALK® radio. When scrolling through the Mode function, your radio features will be displayed in the same predetermined order: Mode/Power CALL MODE S et CTCSS Privacy Codes Set DCS Privacy Codes Set Hi-Mid-Low Power Set Vox On/Off Set Vox Sensitivity Set Call Tones 1-10 Set VibrAlert On/Off Set Roger Beep On/Off Set Key Tones On/Off Set Rewind-Say-Again On/Off Privacy Codes • Your microTALK radio incorporates two advanced coded squelch systems that can help to reduce interference from other users on any given channel. CTCSS (Continuous Tone Coded Squelch System) provides 38 privacy codes and DCS (Digitally Coded Squelch) provides 83 privacy codes. This provides a total of 121 Privacy Codes. Either system can be used on all channels, but both systems cannot be used on the same channel at the same time. To successfully communicate using a privacy code, both the sending and receiving radios must be tuned to the same channel and to the same privacy code system (CTCSS or DCS) and privacy code number. Each channel will remember the last privacy code system and number you select. The privacy code 00 is not a privacy code, but allows all signals to be heard on a channel that is set to 00 on both the CTCSS and DCS systems. VOLUME VOLUME CHANNEL Introduction Operation Customer Assistance Warranty Set CTCSS Privacy Codes • Mode/Power To select a CTCSS privacy code: CALL 1. After selecting a channel, press MODE the Mode/Power button until the CTCSS icon RX Vox appears and the small numbers next to the HI MED LO WX channel number flash on the display. Privacy TCWoDdCeS Scan CTCSS Mem If DCS is turned on at the channel selected, the display will flash the CTCSS icon and "OFF." To switch from DCS to CTCSS, MEM ESC WBTARTICUH RPSCAPN ower Saver press the Channel Up or Channel Down Channel Button button while the display is flashing "OFF." The display will then show the small CHANNEL numbers flashing and you will then be able to proceed to step 2. CALL 2. MODE Press using the Channel Up or Channel Down button to select a privacy code. You can hold the Up or Down button for fast advance. 3. When your desired CTCSS privacy code is displayed, press the Mode/Power button to enter the new setting and proceed to other functions, or press Talk button to enter the new setting and return to Standby mode. 6 Nothing Comes Close to a Cobra® 7