Cobra XRS 9570 XRS 9570 Manual - Page 9
IntelliMute Pro, CAUTION, below, Voice - radar
View all Cobra XRS 9570 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Your Detector Settings IntelliMute Pro IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended for use by experienced users only. When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute activation point, your detector's radar detection circuits are turned Off to prevent detection by RDDs. Before IntelliMute Pro can be turned On, you must have turned On and Set the IntelliMute activation point. (See pages 9 through 11.) CAUTION When IntelliMute Pro is On, NO radar signals will be detected and NO alerts will be given at RPMs below the IntelliMute activation point. IntelliMute Button City Button IntelliMute Pro On Press and hold both buttons simultaneously i h To Turn IntelliMute Pro On While no signal Tone is being detected, press and hold both Two beeps the IntelliMute and City buttons for four seconds. To Turn IntelliMute Pro Off Press and hold both Tone the IntelliMute and City buttons for four One beep seconds. 12 English NOTE The arrow up or down will continue to show that engine RPMs are above or below the user-set value. Voice IntelliMute Pro On Visual Display i blinks continuously in the display after IntelliMute Pro On blinks Voice IntelliMute Pro Off Visual Display None, after IntelliMute Pro Off blinks Your Detector Settings Voice/Tone Setting You can set your detector to sound alerts with either a Voice or a Tone. You can change settings by using the Mute button. In Voice Alert mode, you will first hear several tones, then a voice message announcing the type of signal detected, followed by more tones. In Tone Alert mode, you will hear the tones only. The factory setting is Voice Alert mode. Mute Button Press and hold for two seconds To Change From Voice Alert to Tone Alert While no signal is being detected, press and hold the Mute button for two seconds. Tone One beep Voice Tone Alert To Change From Tone Alert Back to Voice Alert While no signal is being detected, press and hold the Mute button for two seconds again. Tone None Voice Voice Alert Visual Display None, after Tone blinks in the display Visual Display None, after Voice blinks in the display Nothing Comes Close to a Cobra® 13