Cobra XRS 9645 XRS9645_MANL - Page 6

in Icons EasySet Programming Your Detector Intro Operation Customer Warranty EasySet ProAgssisrtaancemming • All user mode settings on your detector can be changed by using Intro Program mode. Operation Customer When Warranty changing the settings, please keep in mind: Assistance s Buttons can have multiple functions. Secondary Icons s All settings will be stored in memory when the power is condary Icons turned Off and recalled when the power is turned back On. in Icons The procedure for using Program mode is shown on page 7. NOTNEotice You cannot enter Program mode during an alert. The unit will not Notice detect signals while in Program mode. During programming, if no Intro Operation buCtutsotomnesr areWparruanstyhed for ten seconds, the unit will automatically exit Assistance Program mode and save the last settings. condary Icons Programming User Modes The tables on pages 8 through 9 show you how to program all user modes and the settings you can choose from. NOTE On the following pages, you will find more detailed explanations Notice of each setting. See page 14 for instructions on setting the IntelliMute activation point. See page 17 for instructions on calibrating the compass. See page 22 for instructions on using SmartPower. 6 English Your Detector Intro Operation EasySet Programming Customer Assistance Warranty Set/City Button Press and release Secondary Icons Select/Dim Button Press and release Program/Mute Button Press and hold/Press and release To Use Program Mode Press and hold the Program/Mute button Notice for two seconds. Tone Three beeps Visual Display Program will appear. PROGRAM Then brief programming instructions will scroll through the display three times. While the programming instructions are scrolling, press and release the Select/Dim button to cycle through the user modes. One beep with each button press As each mode is displayed, the current setting for that mode will be shown. With the user mode you One or two beeps, wish to change displayed, depending on your press and release the selection Set/City button to change the setting. The setting you select will be shown. To move to the next selection, press the Select/Dim button again. When you have finished programming any or all of the user modes, press and release the Program/Mute button to exit Program mode. Or simply wait ten seconds without pushing any buttons. One beep When you exit Program mode, the new setting will automatically be saved and EXIT PROGRAM and Settings Saved! will appear in the display. EXIT Settings PROGRAM Saved! Nothing Comes Close to a Cobra® 7