Compaq dx1000 Service Reference Guide: Compaq dx1000 Microtower PC - Page 64
CAUTION, Installing the Hard Drive in the Drive Cage
View all Compaq dx1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
2. Slide the new drive into the hard disk drive cage (1), aligning the drive with the four screw holes on the cage. Install the four 6-32 standard screws that secure the hard disk drive to the hard disk drive cage (2). Make sure the hard disk drive cables are facing the top of the drive cage. NOTE: If you are replacing an old drive with a new drive, use the four retainer screws from the old drive to install the new drive. NOTE: If you are installing a second hard drive, use four of the extra standard 6-32 screws that are installed on the interior of the front bezel. The 6-32 screws are silver. Figure 6-32 Installing the Hard Drive in the Drive Cage 3. Connect the power cable (1) and data cable (2) to the back of the hard drive. Figure 6-33 Connecting the Hard Drive Cables CAUTION: Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A sharp bend can break the internal wires. 58 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis