Craftsman 25cc Operation Manual - Page 19
Cleaning And Storage
View all Craftsman 25cc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
CLEANING AND STORAGE CLEANING Use a small brush to clean the outside of the unit. Do not use strong detergents. Household cleaners that contain aromatic oils such as pine and lemon, and sol vents such as kerosene, can damage plastic housing or handle. Wipe o any moisture with soft cloth. STORAGE • Remove propane canister. • Never store the unit with attached propane canister where fumes may reach an open ame or spark. • Allow the engine to cool before storing. • Lock up the unit to prevent unauthorized use or damage. • Store the unit in a dry, well-ventilated area. • Store unit out of reach of children. WARNING: TO AVOID SERIOUS INJURY, ALWAYS TURN YOUR UNIT OFF AND ALLOW IT TO COOL BEFORE YOU SERVICE IT. LONG TERM STORAGE 1. Remove propane canister. 2. Allow the engine to cool. Remove the spark plug and put 5 drops of high quality motor oil into the cylinder. Pull the starter rope slowly to distribute the oil. Rein stall the spark plug. NOTE: Remove the spark plug and drain all of the oil from the cylinder before attempting to start the trimmer after storage. 3. Change the oil, referring to Changing the Oil (p.13) . Dispose of the old oil in accordance to Federal, State and Local regulations. 4. Thoroughly clean the unit and inspect for any loose or damaged parts. Repair or replace damaged parts and tighten loose screws, nuts or bolts. The unit is ready for storage. TRANSPORTING • Allow the engine to cool before transporting. • Secure the unit while transporting. • Remove propane canister. TROUBLE SHOOTING ENGINE WILL NOT START CAUSE ACTION EMPTY PROPANE CANISTER INSTALL FULL CANISTER BAD SPARK PLUG REPLACE THE SPARK PLUG ENGINE WILL NOT IDLE CAUSE ACTION AIR FILTER IS PLUGGED REPLACE THE AIR FILTER IMPROPER CARBURETOR ADJUSTMENT ADJUST ACCORDING TO THE 'C ARBURETOR ADJUSTMENTS ' SECTION OR TAKE TO AN AUTHORIZED SERVICE DEALER FOR AN ADJUSTMENT ENGINE WILL NOT ACCELERATE CAUSE ACTION CUTTING ATTACHMENT BOUND WITH GRASS STOP ENGINE AND CLEAN THE CUTTING ATTACHMENT DIRTY AIR FILTER ENGINE LACKS POWER OR STALLS WHEN CUTTING CAUSE BAD SPARK PLUG CLEAN OR REPLACE THE AIR FILTER ACTION IF FURTHER ASSISTANCE IS REQUIRED, CONTACT A QUALIFIED SERVICE DEALER . LEHR | ALL RIGHTS RESERVED 2008-2009 19