Craftsman 25cc Operation Manual - Page 9

INSTALLING ATTACHMENTS INSTALLING CUTTING ATTACHMENTS OR ADD-ONS NOTE: Place the unit on the ground or on a work bench to make accessory installation or removal easier. 1. Turn knob counterclockwise to loosen (Fig. 10). 2. While rmly holding the attachment, push it straight into coupler (Fig. 10). NOTE: Aligning the release button with receiving hole will help installation (Fig. 10). Line up parts Coupler Receiving Hole Release Button NOTE: Always install the attachment so that the engine is upright (propane tank on bottom) when unit is oper ated. A secondary receiving hole is provided for use of a trimmer being used for edging only. No other accessory should be used in this secondary hole (90° edging hole) ( Fig. 11). REMOVING CUTTING ATTACHMENTS OR ADD-ONS 1. Turn the knob counterclockwise to loosen (Fig. 12). 2. Press and hold the release button (Fig. 12). 3. While rmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the coupler (Fig. 12). Upper Shaft Housing Knob Fig. 10 Attachment Housing Coupler Release Button 90° Edging Hole Fig. 12 Fig. 11 3. Turn the knob clockwise to tighten (Fig. 11). Unit is ready to use. 4. For edging (when using the string trimmer head cut ting attachment) lock the release button of the cut ting attachment into the 90° edging hole (Fig. 11), so that the engine remains in the upright position while operating. NOTE: Lock the release button in the receiving hole and securely tighten the knob before operating this unit. NOTE: Attachments are to be used in the receiving hole only. Using the wrong hole could lead to personal injury or damage to the unit. WARNING: TO AVOID SERIOUS INJURY AND DAMAGE TO THE UNIT, SHUT OFF THE UNIT BEFORE REMOVING OR INSTALLING ATTACHMENTS OR ADD-ONS. LEHR | ALL RIGHTS RESERVED 2008-2009 9