Craftsman 28927 Operation Manual - Page 32
CHART, appropriate, manual
View all Craftsman 28927 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM Poor grass discharge Headlight(s) not working (if so equipped) Battery will not charge Loss of drive Engine "backfires" when turning engine "OFF" Engine dies when tractor is shifted into reverse CAUSE CORRECTION 1 Engine speed too slow. 2 Travel speed too fast. 1 Place throttle control in "FAST" position. 2 Shift to slower speed. 3 Wet grass. 4 Mower deck not level. 3 Allow grass to dry before mowing. 4 Level mower deck. 5 Low/uneven tire air pressure. 6 Worn, bent or loose blade. 7 Buildup of grass, leaves and trash under mower. 8 Mower drive belt worn. 9 Blades improperly installed. 5 Check tires for proper PSI. 6 Replace/sharpen blade. Tighten blade bolt. 7 Clean underside of mower housing. 8 Replace mower drive belt. 9 Reinstall blades sharp edge down. 10 Improper blades used. 10 Replace with blades listed in this manual. 11 Clogged mower deck vent holes 11 Clean around mandrels to from buildup of grass, leaves, and trash around mandrels. open vent holes. 1 Light switch is "OFF". 2 Bulb(s) or lamp(s) burned out. 3 Faulty light switch. 4 Loose or damaged wiring. 5 Blown fuse. 1 Turn light switch "ON". 2 Replace bulb(s) or lamp(s). 3 Check/replace light switch. 4 Check wiring and connections. 5 Replace fuse. 1 Bad battery cell(s). 2 Poor cable connections. 1 Replace battery. 2 Check/clean all connections. 3 Faulty regulator (if so equipped). 4 Faulty alternator. 1 Freewheel control in "DISENGAGED" position. 2 Debris on steering plate (if equipped). 3 Motion drive belt worn, damaged, or broken. 3 Replace regulator. 4 Replace alternator. 1 Place freewheel control in "ENGAGED" position. 2 See "CLEANING" in the maintenance section. 3 Replace motion drive belt. 4 Air trapped in transmission during 4 Purge transmission. shipment or servicing. 5 Axle key missing. 5 Install axle key at rear wheel. See "TO REMOVE WHEEL" in the Service and Adjustments section. Engine throttle control not sel 1 between half and full speed (fast) position before stopping engine, Move throttle control between half and full speed (fast) position before stopping engine. 1 Reverse operation system (ROS) 1 Turn ignition key to ROS "ON" is not "ON" while mower or other position. See Operation section. attachment is engaged. 32