Craftsman 28970 Operation Manual - Page 25
Engine
View all Craftsman 28970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
TO REMOVE CABLES, REVERSE ORDER1. BLACK cable first from chassis and then from the fully charged battery. 2. RED cable last from both batteries. REPLACING BATTERY ,_WARNING: Do not short batteryterminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from accidental grounding. 1. Lift hood to raised position. 2. Disconnect BLACK battery cable (A) then RED battery cable and carefully remove battery from tractor. 3. Install newbatterywithterminals position as old battery. in same 4. First connect RED battery cable (B) to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover (C) over terminal. 5. Connect BLACKgrounding cableto negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely 6. Close hood. TO REPLACE FUSE Replace with 30 amp automotive-type in fuse. The fuse holder is located the dash. plugbehind TO REMOVE HOOD & GRILL ASSEMBLY 1. Raise hood. 2. Unsnap headlight wire connector. 3. Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor. . When replacing hood, be sure to reconnect the headlight wire connector. Hood Headlight Wire Connector Negative (Black) Cable TRANSMISSION REMOVAL OR REPLACEMENT Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor. See "PURGE TRANSMISSION" in the Operation section of this manual. Positive (Red) Cable TO REPLACE HEADLIGHT BULB 1. Raise hood. 2. Remove bulb holder from the hole in the backside of the grill. 3. Replace bulb in holder and install bulb holder securely back into the hole in the backside of the grill. 4. Close hood. INTERLOCKS AND RELAYS Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting. • Check wiring. See electrical wiring diagram in the Repair Parts manual. ENGINE TO ADJUST THROTTLE CONTROL CABLE The throttle control has been preset at the factory and adjustment should not be necessary Check adjustment as described below before loosening cable. If adjustment is necessary, see engine manual. TO ADJUST CHOKE CONTROL The choke control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual. TO ADJUST CARBURETOR Your carburetor has been preset at the factory and adjustment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the engine does need adjustment, see engine manual. 25