Craftsman 28986 Operation Manual - Page 35
SearsParts&RepairCenter
View all Craftsman 28986 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Whilenormacl areandregularmaintenancweillextend thelifeofyourequipmenpt,rolongedor constanut se mayeventuallryequirethatservicebe performetdo allow ittocontinueoperatingproperlyT. hetroubleshooting guidebelowliststhe mostcommonproblemsth, eircausesandremedies. If youprefera, lloftheseprocedurecsanbeperformed foryoubya SearsParts& RepairCenterS. eetheback coverforimportanSt earsParts&RepairCenterinformation. AWARNING To avoid serious injury, perform maintenance on the rider or mower only when the engine is stopped and the ground speed levers are set to PARK. Always remove the ignition key, disconnect the spark plug wire and fasten it away from the plug before beginning the maintenance, to prevent accidental starting of the engine. Troubleshooting the Rider PROBLEM CAUSE REMEDY Engine will not turnover or start. Ground speed levers not set to START/PARK. Mower blade switch in ON position. Set to START/PARK. Place in OFF position. Ground speed levers not set to START/PARK. Choke not in CLOSED position. L Ignition switch not turned fully to START position. Set to START/PARK. Move choke to CLOSED position. Turn ignition switch fully to START position. IOut of fuel. Allow engine to cool, then refill the fuel tank. i Engine flooded. Set choke to OPEN position when cranking engine. Fuel is old or stale, or water in fuel. i Battery terminals require cleaning. IBattery discharged or dead. Spark plug(s) faulty, fouled or incorrectly gapped. Drain fuel & replace with fresh fuel. Contact Sears Parts & Repair. Clean the battery terminals. Recharge or replace. Clean and gap or replace. iWiring loose or broken. Visually check wiring & replace broken or frayed wires. Tighten loose connections. ISolenoid or starter motor faulty. i Safety interlock switch faulty. Engine starts iAir filter plugged. hard or runs Replace. Contact Sears Parts & Repair. Replace. Contact Sears Parts & Repair. Service pre=cleaner and/or replace air filter element. poorly. Choke not set to CLOSED position when i cranking the engine, OR choke not set to OPEN after engine starts, Set choke to CLOSED when cranking. Set choke to OPEN when engine is running. Awarm engine may not require choking. Spark plug faulty, fouled, or incorrectly gapped. Clean and gap or replace. Engine knocks, Low oil level. i Using wrong grade oil. Excessive oil i Engine running too hot. consumption, i Using wrong weight oil. Too much oil in crankcase. Check/add oil as required. See "Change Engine Oil" in the Maintenance Section. Clean engine cooling fins, blower screen and air cleaner. See "Change Engine Oil" in the Maintenance Section. Drain excess oil. Engine exhaust is black. i Dirty air filter or pre-cleaner, or both. Choke set to CLOSED when engine is running. Service or replace as required. See Maintenance Section. Set choke to OPEN as soon as engine starts. 35