Cub Cadet 3X 30 HD 3X 26034 Operator's Manual - Page 15

Controls and Features

Page 15 highlights

Controls and Features 4 Drive Control Chute Assembly Drift Cutter † Clean Out Tool Headlight Shift Lever 4-Way Chute Directional Control/ Two-Way Chute-Pitch Control † Auger Control Heated Grips † Steering Trigger Control Overhead Chute Directional Control † Augers Skid Shoe † If Equipped Figure 4-1 Snow thrower controls and features are described below and illustrated in Figure 4-1. Shift Lever The shift lever is located in the right side of the handle panel and is used to determine ground speed and direction of travel. Forward There are six forward (F) speeds. Position one (1) is the slowest and position six (6) is the fastest. Reverse There are two reverse (R) speeds. One (1) is the slower and two (2) is the faster. Skid Shoes Position the skid shoes based on surface conditions. Adjust upward for hard-packed snow. Adjust downward when operating on gravel or crushed rock surfaces. See Set-Up & Assembly section. Augers When engaged, the augers rotate and draw snow into the auger housing. Chute Assembly Snow drawn into the auger housing is discharged out the chute assembly. Headlight The headlight is located on the handle panel and is automatically turned on when the engine is started. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

Controls and Features
4
15
Snow thrower controls and features are described below and
illustrated in Figure 4-1.
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward
There are six forward (F) speeds. Position one (1) is
the slowest and position six (6) is the fastest.
Reverse
There are two reverse (R) speeds. One (1) is the
slower and two (2) is the faster.
Skid Shoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces. See Set-Up &
Assembly section.
Augers
When engaged, the augers rotate and draw snow into the auger
housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute
assembly.
Headlight
The headlight is located on the handle panel and is automatically
turned on when the engine is started.
† If Equipped
Drive Control
Headlight
Chute Assembly
Clean Out
Tool
Drift Cutter †
Augers
Skid Shoe
Shift Lever
4-Way Chute Directional Control/
Two-Way Chute-Pitch Control †
Auger Control
Steering Trigger Control
Overhead Chute
Directional Control †
Heated Grips
Figure 4-1