Cub Cadet 3X 30 HD 3X 26034 Operator's Manual - Page 8
Way Assembly
View all Cub Cadet 3X 30 HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
4-Way Assembly Remove all loose parts before assembling. Handle Assembly 1. Place the shift lever in the Forward-6 position as shown in Figure 3-1 inset. 2. Cut zip ties securing chute control rod to the lower handle and set it aside. 3. Observe the lower rear area of the snow thrower to be sure both cables are aligned with roller guides before pivoting the handle upward. Pivot the handle upward. 4. Secure the handle by tightening the plastic knob located on both the left and right sides of the handle. Remove and discard any rubber bands, if present. They are for packaging purposes only. Chute Assembly 1. Remove hairpin clip, wing nut and hex screw from chute control head and clevis pin and bow-tie cotter pin from chute support bracket. See Figure 3-3. Chute Control Head Chute Support Bracket Chute Chute Base Figure 3-1 NOTE: Make certain the cables are seated properly in the roller guides. See Figure 3-2. Figure 3-3 2. Insert chute control rod into chute control head. Push rod as far into chute control head as possible, keeping the holes in the rod pointing upward. See Figure 3-4. Figure 3-2 8 Section 3- Assembly & Set-Up Figure 3-4 3. Place chute onto chute base and ensure chute control rod is positioned under the handle panel. Install hex bolt previously removed but do not secure with wing nut at this time. See Figure 3-5.