Cub Cadet 3X 30 inch HD Operation Manual - Page 12
Overhead Chute Control w/ Flex Shaft & Steel Chute
View all Cub Cadet 3X 30 inch HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
7. Push chute control rod toward control panel until hole in rod lines up with hole in chute control input closest to chute control head and insert hairpin clip (a) removed in Step 1. See Figure 2-33. Overhead Chute Control (w/ Flex Shaft & Steel Chute) (a) Figure 2-33 NOTE: Second hole is used to achieve further engagement of chute control rod into pinion gear if required. Refer to Service section for Chute Control Rod adjustments. 8. Finish securing chute control head to chute support bracket with wing nut (b), clevis pin (d), and bow-tie cotter pin (e) removed in Step 1. STOP Continue to Set-Up (page 14) Figure 2-34 1. Remove lock nuts (a) and hex screws (b) from chute support bracket (this will require two wrenches). See Figure 2-35. (a) Chute Control Head (a) (a) (a) Chute Assembly (b) (b) Chute Base Chute Support Bracket Figure 2-35 2. Place chute assembly onto chute base and chute control head onto chute support bracket. See Figure 2-36. 3. Secure chute control head to chute support bracket with lock nuts (a) and hex screws (b) removed in Step 1. See Figure 2-36. (b) (b) Figure 2-36 NOTE: For smoothest operation, cables should all be to the left of the chute directional control rod. 4. Remove hairpin clip (a) from rear of chute control assembly. See Figure 2-37. (a) (b) Figure 2-37 12 Section 2 - Assembly & Set-Up