Cub Cadet 3X 30 inch HD Operation Manual - Page 13
Electric Chute Control
View all Cub Cadet 3X 30 inch HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
5. Insert flex shaft (b) removed during Handle Assembly from lower handle into rear of chute directional control head. See Figure 2-37. Secure flex shaft to chute control head with hairpin clip (a) removed in Step 4. 6. Insert hex end of flex shaft into chute control rod coupling under dash panel. See Figure 2-38. Electric Chute Control Figure 2-38 7. Ensure speed selector is in fastest forward speed. 8. Remove cotter pin (a) and washer (b) from ferrule on end of shift rod. See Figure 2-39 inset. Ferrule (a) (b) Shift Rod Figure 2-39 9. Make sure the shift lever on the back of the transmission is rotated downward to the full extent of its rotation. See Figure 2-40. Figure 2-40 10. Insert ferrule into top hole of shift lever and secure with cotter pin (a) and washer (b) removed in Step 8. See Figure 2-39. Ferrule may need to be adjusted up or down. STOP Continue to Set-Up (page 14). Figure 2-41 1. Remove cotter pin (a), wing nut (b) and hex screw (c) from chute control head. Remove clevis pin (d) and bow-tie cotter pin (e) from chute support bracket. See Figure 2-42. Chute Control Head (c) (d) (a) (e) 2 1 1 Chute (b) Chute Support Bracket 3. Place chute onto chute base and ensure chute control rod is positioned under handle panel. Secure chute control head to chute support bracket with clevis pin (d) and bow-tie cotter pin (e) removed in Step 1. See Figure 2-44. (d) (e) Chute Base Figure 2-42 NOTE: For smoothest operation, cables should all be to the left of the chute directional control rod. 2. Insert round end of chute control rod into chute control head. Push rod as far into chute control head as possible, keeping holes in rod pointing upward. See Figure 2-43. Figure 2-44 4. Finish securing chute control head by installing hex screw (c) and wing nut (b) removed in Step 1. See Figure 2-45. (c) Figure 2-43 (b) Figure 2-45 Section 2 - Assembly & Set-Up 13