Cuisinart BJC-550 User Manual - Page 7
Compact Juice, Extractor Operation, Compact Blender And, Juice Extractor Combo, Cleaning
View all Cuisinart BJC-550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Remove the pulp container from the side of the motor base and empty. COMPACT JUICE EXTRACTOR OPERATION 1. Make sure your Juice Extractor Attachment is properly assembled (see Page 6) and attached to the motor base. 2. Plug the power cord into the 120V electrical outlet. 3. Wash all selected fruits or vegetables. 4. While many fruits and vegetables will not need cutting, any item with a diameter larger than 2 inches will need to be cut. 5. Turn the dial from the STOP position to HIGH. 6. Lift the food pusher out of the feed tube and drop your food into the opening. Push through by inserting the food pusher and pressing firmly. Do not pack the feed tube too full of food. Be sure that the food has been processed through the filter basket/ blade before adding more items. Note: When using leafy vegetables with stems, please put the leafy end into the feed tube first followed by the stem. Do not over pack feed tube. 7. The juice will flow into your glass and the pulp will accumulate in the pulp container. 8. When finished juicing, turn the dial to the STOP position to stop the motor. COMPACT BLENDER AND JUICE EXTRACTOR COMBO CLEANING AND MAINTENANCE Always unplug your Cuisinart® Compact Blender and Juice Extractor Combo from the electrical outlet before cleaning. The base and parts are made of corrosion-resistant materials that are easy to clean. Before first use and after every use, clean each part thoroughly. Periodically check all parts before reassembly. DO NOT USE IF ANY PART IS DAMAGED, OR IF THE BLENDER CUP IS CHIPPED OR CRACKED. To remove blade assembly, twist off by turning clockwise. NEVER TOUCH THE BLADE. CAUTION: Handle the blade assembly carefully. Blades are SHARP and may cause injury. DO NOT attempt to remove blades from cutting assembly, do not attempt to detach the blade assembly from Blade collar. Wash all parts in warm, soapy water. Rinse and dry thoroughly. All parts are top rack dishwasher safe. Tip: You may wish to clean your blade assembly cutting assemblies as follows: Squirt a small amount of dishwashing liquid into blending cup and fill halfway with warm (not hot) water. Attach blade assembly and run on Low for 15 seconds. Repeat, using clean tap water. Carefully disassemble parts and empty blending cup. Rinse and dry all parts thoroughly. Finally, wipe the motor base clean with a damp cloth to remove any residue, and dry thoroughly. Never submerge the motor base in water or other liquids, or place in a dishwasher. Any other servicing should be performed by an authorized service representative. 7