Cuisinart SS-700 SS-700 Manual - Page 9

8. Making sure your mug is in place, press the Brew button to start a cleansing cycle (unit will dispense approximately 8 oz. of water). The control panel will display BREWING, as well as the factory default brew size (see figure 5). When cycle is complete, dispose of the hot water. Note: Do not use a K-Cup® for this cycle. The one-time set-up process is complete. figure 5 Charcoal Water Filter Your coffeemaker comes with a charcoal water filter that eliminates chlorine, bad tastes and odors from tap water. Upper Filter Holder 5. Flush filter by running fresh water through lower portion of the filter holder. 6. Allow the filter to drain completely. 7. Place the assembled water filter holder into the water reservoir, pushing it down to fit into place (see figure 7). Water Reservoir Lid Charcoal Water Filter PRESS TABS Lower Filter Holder figure 6 assembled Charcoal Water Filter Water Reservoir Inserting the Water Filter 1. Remove the filter and filter holder from the polybags. 2. Soak the filter, fully immersed in cold tap water, for 15 minutes. 3. Remove lower portion of filter holder by pressing the tabs on the sides and pulling apart. Rinse with fresh water. 4. Insert the charcoal filter into the upper filter holder, then attach the lower portion by pressing on tabs and pushing until it locks into place (see figure 6). figure 7 Note: We recommend changing the water filter every 60 days or after 60 uses, and more often if you have hard water. Replacement filters can be purchased in stores, by calling Cuisinart Customer Service, or at www.cuisinart.com. 9