D-Link DCS-2210L Quick Installation Guide - Page 5
Hardware Installation
![]() |
View all D-Link DCS-2210L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
3. Hardware Installation Basic Connection Connect the camera to your switch or router via Ethernet cable. Connect the supplied power cable from the camera to a power outlet. Connection Using a PoE Switch (DCS-2210 only) If using a PoE switch or router, connect the network camera via Ethernet cable. PoE will transmit both power and data over a single cable. Note: Once power has been established, the LED will turn red. When the device has obtained an IP address and is accessible, the LED will turn green. D-Link DCS-2210/DCS-2230 Quick Install Guide 5
![](/manual_guide/products/dlink-dcs2210l-quick-installation-guide-150989b/5.png)
D-Link DCS-2210/DCS-2230 Quick Install Guide
5
3. Hardware Installation
Basic Connection
Connect the camera to your switch or router via Ethernet cable.
Connect the supplied power cable from the camera to a power outlet.
Connection Using a PoE Switch
(DCS-2210 only)
If using a PoE switch or router, connect the network camera via Ethernet cable.
PoE will transmit both power and data over a single cable.
Note:
Once power has been established, the LED will turn red. When the device has
obtained an IP address and is accessible, the LED will turn green.