D-Link DCS-6004L Quick Install Guide - Page 10

ENGLISH Adjusting the Viewing Angle Refer to the steps below for adjusting the viewing angle of the camera. 1. The camera housing needs to be separated from the camera base to expose the screw 1 used to adjust the viewing angle. Remove the camera housing from the camera base by squeezing the housing release buttons on either side of the camera. 2. Lift the camera housing up off the camera base once the housing has been released. 2 3. Use a Phillips screwdriver to loosen the retaining screw used to secure the 3 viewing angle of the camera lens. 4. Manually adjust the viewing angle back and forth to your desired location. 4 5. Use a Phillips screwdriver to tighten the retaining screw used to secure the 5 viewing angle of the camera lens. 6. Reattach the camera housing by lining up the access port on the housing with the 6 access port on the camera base. Firmly push down until the camera housing snaps back onto the camera base. 10