D-Link DCS-6004L Quick Install Guide - Page 11
Troubleshooting - default password
View all D-Link DCS-6004L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH Troubleshooting 1. How do i connect my camera using WPS? (DCS-6005L only) We recommend that you use either the Zero Configuration or Setup Wizard method described earlier in this guide as they will automatically configure your camera for your wireless network. If you wish to use WPS to connect your camera, follow these steps: • Press and hold the WPS button on the back of the camera for five seconds. The blue WPS status LED will blink. • Press the WPS button on your wireless router or access point within 60 seconds. On some routers, you may need to log into the web interface and then click an onscreen button to activate the WPS feature. If you are not sure where the WPS button is on your router or access point, please refer to your router's user manual. 2. What Should I do if i forget my password? You must reset your camera. Unfortunately, this will change your settings back to the factory default settings. To reset your camera, use an unfolded paperclip to press and hold the RESET button for a minimum of six seconds while your camera is plugged in. 3. How do i connect a speaker to my camera? To connect a speaker to the camera, first remove the camera cover. Then plug the included Audio Out Cable into the white connector on the face of the camera labelled "LINE OUT". 3. How do i FIT THE COVER Over my camera when the cables are connected? If you do not choose to pass the cables for the camera through the wall or ceiling, in order to fit the cover over the camera when cables are connected, you must remove the perforated tabs from the camera cover. Just locate the tabs along the rim of the cover and press until they break loose. 11