D-Link DCS-6510 User Manual - Page 9
Installation - ip camera
UPC - 790069340055
View all D-Link DCS-6510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation 6. Cut the zip-tie at the base of the cables if needed. 7. Use a metric size 21 wrench to loosen the chrome nut where the cable exits the base of the camera. 8. Remove the cable with the nut attached. 9. Loosen and remove the chrome plug from the base of the camera using a coin or screwdriver. 10. Place the cable into the new hole and reconnect the cable connectors to the circuit board. 11. Replace the chrome plug and tighten it into place. 12. Replace the chrome nut and tighten it into place B. Replace the dome enclosure over the IP camera and tighten the 4 screws. C. Insert and tighten the 3 mountings bolts in the holes on the back panel of the camera, as shown here. Safety Notice: Installation and servicing should be done by certified technicians so as to conform to all local codes and prevent voiding your warranty. D-Link DCS-6510 User Manual Mounting Bolts Chrome Nut Chrome Plug Figure 5. Figure 6. 9