D-Link DCS-930L Product Manual - Page 25

Section 4 - Configuration Wireless This section allows you to setup and configure the wireless settings on your camera. SSID: Service Set Identifier, an identifier for your wireless network. Channel: The default setting is channel 6. Select the same channel that is using by other wireless devices within your network. When there is interference from the wireless networks that overlap with one another, you may change the channel to obtain maximum performance for your connection. Connection Mode: Infrastructure is a wireless connection using an access point as a transmission point of all wireless devices. Ad-Hoc is a wireless connection used without an access point, where your DCS-930L is directly connecting to your PC. This is done using the on-board wireless adapter on the DCS-930L connected to a wireless adapter on the PC. Site Survey: This page will allow you to select a wireless network that the DCS-930L was able to detect. Wireless Security For security, there are three choices; None, WEP, and WPA-PSK / WPA2Mode: PSK. Select the same encryption method that is being used by your wireless device/ router. WEP: WEP provides security by encrypting data over your wireless network so that it is protected as it is transmitted from one wireless device to another. To gain access to a WEP network, you must know the key. The key is a string of characters that you create. When using WEP, you must determine the level of encryption. The type of encryption determines the key length. 128-bit encryption requires a longer key than 64-bit encryption. WPA-PSK / WPA2PSK An appropriate Preshared Key, which is needed in order to connect to the wireless network. Settings: D-Link DCS-930L User Manual 25