D-Link DFL-2560 Product Manual - Page 197
Multicast Forwarding - Address Translation Scenario, Creating Multiplex Rules with the CLI
UPC - 790069335433
View all D-Link DFL-2560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
4.6.2. Multicast Forwarding with SAT Multiplex Rules Chapter 4. Routing B. Create an IP rule: 1. Go to Rules > IP Rules > Add > IP Rule 2. Under General enter. • Name: a name for the rule, for example Multicast_Multiplex • Action: Multiplex SAT • Service: multicast_service 3. Under Address Filter enter: • Source Interface: wan • Source Network: 192.168.10.1 • Destination Interface: core • Destination Network: 239.192.10.0/24 4. Click the Multiplex SAT tab and add the output interfaces if1, if2 and if3 one at a time. For each interface, leave the IPAddress field blank since no destination address translation is wanted. 5. Make sure the forwarded using IGMP checkbox is set 6. Click OK Creating Multiplex Rules with the CLI Creating multiplex rules through the CLI requires some additional explanation. First, the IPRuleset, in this example main, needs to be selected as the current category: gw-world:/> cc IPRuleset main The CLI command to create the multiplex rule is then: gw-world:/main> add IPRule SourceNetwork= SourceInterface= DestinationInterface= DestinationNetwork= Action=MultiplexSAT Service= MultiplexArgument={outif1;ip1},{outif2;ip2},{outif3;ip3}... The two values {outif;ip} represent a combination of output interface and, if address translation of a group is needed, an IP address. If, for example, multiplexing of the multicast group 239.192.100.50 is required to the output interfaces if2 and if3, then the command to create the rule would be: gw-world:/main> add IPRule SourceNetwork= SourceInterface= DestinationInterface=core DestinationNetwork=239.192.100.50 Action=MultiplexSAT Service= MultiplexArgument={if2;},{if3;} The destination interface is core since 239.192.100.50 is a multicast group. No address translation of 239.192.100.50 was added but if it is required for, say, if2 then the final argument would be: MultiplexArgument={if2;},{if3;} 4.6.2.2. Multicast Forwarding - Address Translation Scenario 197