D-Link DGS-3620-52T CLI Guide - Page 1084
show port_vlan
View all D-Link DGS-3620-52T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1084 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters - Specify a range of ports to be set. all - Specify to make all ports to be set. gvrp_state - Specify if the port is allowed to dynamically become a member of a VLAN when receiving GVRP. enable - Enable GVRP for the ports specified in the port list. disable - Disable GVRP for the ports specified in the port list. ingress_checking - When ingress checking is enabled, the Switch checks if the incoming packet was assigned a VLAN on which the ingress port is a VLAN member. If the incoming packet and the ingress port are not in the same VLAN, the packet will be dropped. enable - Enable ingress checking for the specified port list. disable - Disable ingress checking for the specified port list. acceptable_frame - Specify the type of frame that will be accepted by the port. tagged_only - Only tagged frame will be received. admit_all - Both tagged and untagged frames will be accepted. pvid - Specify the Port VID (PVID) that will be associated with the port. - Specify the VLAN ID between 1 and 4094. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the port VLAN: DGS-3620-28SC:admin#config port_vlan 1-5 gvrp_state enable ingress_checking enable acceptable_frame tagged_only pvid 2 Command: config port_vlan 1-5 gvrp_state enable ingress_checking enable acceptable_frame tagged_only pvid 2 Success. DGS-3620-28SC:admin# 106-8 show port_vlan Description This command is used to display the GVRP status for a port list on the switch. Format show port_vlan {} Parameters - (Optional) Specify a range of ports to be displayed. Note: If no parameter is specified, the system will display GVRP information for all ports. 1079