D-Link DIS-200G Quick Install Guide - Page 8

ENGLISH 2. Use a lever to remove the terminal block from the switch. Web User Interface Once the switch has been successfully installed, you can begin configuration, monitor the LED panel, and display graphical statistics using a web browser. Supported browsers include: Microsoft® Internet Explorer, Firefox, Chrome, and Safari. You need the following equipment to access the Web UI of your device: Figure 13 3. Using a flat head screwdriver, loosen the connections in the terminal block by un-screwing the terminal connections that you wish to use. 4. Insert the wires into the terminal connections and use the screwdriver to tighten the screws to secure the wires. Figure 14 5. Re-insert the terminal block into the terminal block socket on the DIS-200G. Management Options The DIS-200G can be managed by using the Web User Interface (Web UI), D-Link Network Assistant (DNA), console port, Telnet, or Simple Network Management Protocol (SNMP) management interfaces. If you wish to manage a single D-Link switch, the Web UI may be the best option. Each switch must be assigned its own IP address, which is used for communication with the management PC. However, if you wish to manage multiple D-Link switches, DNA may be the best option. You do not need to change the IP address of your PC and it makes the initial set up of multiple switches easy. Please refer to the following installation instructions to get started with the Web UI, DNA, console port, Telnet, and SNMP management interfaces. • A PC with an RJ-45 Ethernet connection • A standard Ethernet cable 1. Connect the Ethernet cable to any of the ports on the switch's front panel and to the Ethernet port on the PC. 2. Configure the PC's IP address to be in the same network segment as the switch. The switch's default IP address is 10.90.90.90, with subnet mask 255.0.0.0. For example, to connect to the switch using the default settings, your PC should have an IP address in the range: 10.0-255.0-255.0254 and a subnet mask of 255.0.0.0. 3. Openawebbrowserandenterhttp://10.90.90.90/ in the address box. Note: The Web UI can also be accessed through DNA, by clicking the switch's IP in the device list. 4. Log in to the switch. To do this, enter admin as the default user name and password and click OK. D-Link Network Assistant (depending on the purchased model) D-Link Network Assistant (DNA) is a program that is used to discover switches which are in the same Layer 2 network segment as your PC. Please refer to the following steps to get started with DNA. 1. Go to http://tools.dlink.com/intro/dna/ 2. Select "Free Download" button to open DNA download page for download Note: for Managed Switch, users need to enable D-Link Discovery Protocol (DDP) and create a user name and password to be able to log in to DNA." Console To connect to the switch's console, use the supplied cable to connect to the switch's console port. This cable is a RS-232 serial to RJ-45 connector cable 6