D-Link DSR-250v2 Quick installation guide 2 - Page 6

ENGLISH Browser Microsoft Internet Explorer Mozilla Firefox Version 6.0 or higher 3.5 or higher Netscape Navigator 9.0 or higher Apple Safari 4.0 and later Google Chrome 3.0 and later Table 4. Browser Compatibility To access the device with the WebUI: 1. Connect your workstation on the port labeled LAN (1-4), which is pre-allocated to the LAN. 2. Ensure your workstation is configured with a static IP address in the 192.168.10.0/24 subnet. Note: Disable pop-up blocking software or add the management IP address Https://192.168.10.1 to your pop-up blocker's allow list. 3. Launch your browser; enter the IP address for the LAN interface. (The factory default IP address is Https://192.168.10.1), then press Enter. Figure 6. Browser Address 4. Log on the Wireless AC Services Router Web Interface The default log on information is: Username: admin Password: admin Figure 7. Authentication Message 4  D-Link Wireless AC Services Router Using a Console Connection (RJ45-to-DB9 DCE) The Wireless AC Services Router provides an serial port that enables a connection to a computer or terminal for monitoring and configuring the device. This port is a RJ-45 connector, implemented as a data communication terminal equipment (DCE) connection. To use the console port connection, you need the following equipment: 1. A terminal or a computer with both a serial port and the ability to emulate a terminal. 2. A RJ45-to-DB9 RS-232 with female connector. (Already included in packing list) 3. If your Laptop or PC doesn't have RS-232 connector, a converter is required. Note: DSR-500AC/1000AC does not come with RS-232 converter and these must be purchased separately. To establish a console connection: 1. Plug the RJ-45 connector of the supplied RJ45-to-DB9 cable directly to the console port on the Wireless AC Services Router. 2. Connect the other end of the cable to a terminal or to the serial connector of a computer running terminal emulation software. Set the terminal emulation software as following: Baud rate: 115200 Data bits: 8 Parity: None Stop bits: 1 Flow control: None 3. When you have correctly set up the terminal, having previously followed the instructions in section 2.3, "Connecting Power and Turn the Device On/Off" then switch on your device. The boot sequence appears in the terminal. 4. Once the boot sequence completes, the command prompt is displayed, the device is ready to be configured.