DELPHI SA10034 Owners Manual - Page 10

Figure 15 3. Holding the central unit steady, press the back of the inset cradle, then allow it to tilt forward. Carefully slide the SKYFi Receiver down into the cradle (Figure 16). The alignment slots on the receiver should line up with the tabs inside the cradle. At the same time, the receiver should be securely seated with the connector. Press the top center of the SKYFi Receiver display, tilting it back into the Delphi CD Audio System with a firm but gentle click. Remove the SKYFi Receiver by reversing this process (Figure 17). Figure 16: Insertion of SKYFi Receiver Into Cradle 4. Press "Power" on the SKYFi Receiver or Delphi CD Audio System remote to power up SKYFi. 5. If the display reads "ANTENNA" after powering up, check that the antenna connection is secure and completely engaged. Next, change channels (from 0 to 1 or from 1 to 0 if the receiver is not yet activated). If the "ANTENNA" message remains, power down the radio, unplug the antenna, and look for any obvious damage to the connector, jack, or antenna cable. If no damage is detected, reconnect the antenna, turn the unit back on, and change channels again. Contact your retailer if the message still appears. 6. If the display reads "NO SIGNAL" after powering up, follow the instructions below and on page 9 for positioning the XM antenna and optimizing its signal. Once the Delphi CD Audio System is set up and the SKYFi Receiver is inserted in its cradle, refer to the SKYFi Operating Guide for complete system operation and control information. Positioning the XM Antenna The XM antenna that comes with your Delphi CD Audio System is a high-gain antenna that can receive XM's signal from XM's satellites and/or, depending on where you live, XM's land-based repeaters. It is recommended that the antenna be positioned near a south-facing window or outdoors with a clear view of the southern sky in order to receive the satellite signal. In some cases, it will be possible to receive XM's signal through standard home walls or a roof. To position your antenna, first set up the Delphi CD Audio System as described earlier in this guide. Next, position the antenna until you receive the strongest possible satellite signal (refer to Optimizing XM Antenna Signal, page 9). If a satellite signal is not available, you can optimize your antenna for a terrestrial signal (signal from land repeater, where available). PRESS MENU TO EXIT SATELLITE Terrestrial SECT ION 3 Figure 17: SKYFi Receiver Removal From Cradle 8 Figure 18