DELPHI SA10034 Owners Manual - Page 12

1.4 in (35 mm) Your antenna comes with 10 feet of cable. If that is not sufficient to locate the antenna where there is a strong XM signal, you may purchase a 50-foot cable extension (Delphi model number SA10006) from your SKYFi retailer. Up to two extensions can be used together for up to 110 total feet of cable. Outdoor Installation or Indoor Wall Mounting For maximum flexibility and convenience, your XM antenna can also be attached vertically to an external or internal wall. 1. Holding the antenna up, find a wall location that provides a strong signal. It is recommended that you use an extension cord to temporarily locate your Delphi CD Audio System outdoors while optimizing the antenna location with the "Antenna Aiming" screen. 2. Attach four screws to the wall using the screwlocator pattern in Figure 22. (First, photocopy the pattern to use as a template.) Use screws with head sizes small enough to fit in the center of each of the four holes but large enough not to pop out of the elongated sections. #4 pan-head screws (3/8-inch long) are recommended. Leave 1/8 inch of the screw shanks visible between the heads and the wall. 1.6 in (40 mm) Figure 22: Screw Locator Pattern 3. Tilt the antenna fully back on its base. Place the antenna base on the four screw heads with the antenna pivot at the top, and pull down approximately 3/8 inch until the base is firmly secured on the wall. (Note that the XM logo will be upside down when the antenna is properly installed.) 4. Tilt the antenna away from the wall/base until the signal is optimized. Note: Do not cut the antenna cable and attach alternative connectors or cable. The cable and connectors included with your Delphi CD Audio System are specially chosen to ensure that they will work with XM's unique frequency band. Use only an XMapproved extension kit (Delphi model number SA10006) with your SKYFi system. Controlling Volume, Bass, and Treble Controlling Volume Use the volume knob on the SKYFi panel or the Vol+/- keys on the remote control to adjust volume when playing XM Satellite Radio stations. If you also use your SKYFi Receiver with a SKYFi Vehicle Adaptor or Home Adaptor kit, the SKYFi Receiver will remember the volume level previously set when connected to the Delphi CD Audio System and will return to that setting the next time the system is used. Note that the "Line Out" level cannot be reset while the SKYFi Receiver is in the Delphi CD Audio System since the volume control should be used to control the audio output. If the line out setting is adjusted while the receiver is in the SKYFi Vehicle Cradle or Home Stand and is later reconnected to the Delphi CD Audio System, it will automatically return to the prior setting the next time it is used in the SKYFi Vehicle Cradle or Home Stand. Bass and Treble In SKYFi mode, bass and treble can be adjusted by pressing the "Menu" button on the SKYFi Receiver or remote, selecting "Bass + Treble," and then setting these features in the same manner as other menu functions*. If the SKYFi Receiver is removed from the Delphi CD Audio System and used in a vehicle or home adaptor, the bass and treble settings on the SKYFi Receiver display will be "flat" or "zero" since the audio signal will be processed by the vehicle or home audio system. When the SKYFi Receiver is returned to its cradle in the Delphi CD Audio System, it will resume the most recent bass and treble settings. *Refer to the SKYFi Operating Guide for more specific information on operating your SKYFi Receiver. SECT ION 3 10