DeLonghi PAC WE130 Owner Manual - Page 18

Problem, Cause, Solution

Page 18 highlights

TROUBLESHOOTING PROBLEM CAUSE SOLUTION The air conditioner does not come on The air conditioner works for a short time only • No electricity • It is not plugged into the socket • The internal safety device has tripped • The safety device of the plug has tripped • There are bends or kinks in the air exhaust hose • Something is preventing the air from being discharged The air conditioner works, but does not cool the room • Windows, doors and/or and/or curtains are open • There are heat sources in the room (oven, hairdryer, etc.) • Restore electricity • Plug into the socket •Wait 30 minutes, if the problem persists, contact your service center • Reset the safety plug • Position the air hose correctly, keeping it as short and free of curves as possible to avoid bottlenecks • Check and remove any obstacles obstructing air discharge • Close doors, windows and curtains, bearing in mind the "tips for correct use" stated on pg. 15 • Eliminate the heat sources •The air exhaust hose is detached from the appliance • Fit the air exhaust hose in the housing at the back of the appliance (fig. 1) • Dust filter and (when present) silver ion filter and 3M® filter clogged • Clean the filters as described in the "Cleaning" section (pg. 16) During operation, there is an unpleasant smell in the room • The technical specification of the appliance is not adequate for the room in which it is located • Dust filter and (when present) silver ion filter and 3M® filter clogged The air conditioner does not operate for about three minutes after restarting it • The internal compressor safety device prevents the appliance from being restarted until three minutes have elapsed since it was last turned off • Clean the filters as described in the "Cleaning" section (pg. 16) • Wait. This delay is part of normal operation The symbol and one of the following messages appears on the appliance display: L T / P F / H L / C L • The appliance has a self diagnosis system to identify a number of malfunctions 18 •See the SELF-DIAGNOSIS section (pg.14)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

18
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The air conditioner
does not come on
• No electricity
• It is not plugged into the socket
• The internal safety device has
tripped
• The safety device of the plug
has tripped
• Restore electricity
• Plug into the socket
•Wait 30 minutes, if the problem
persists, contact your service
center
• Reset the safety plug
The air conditioner
works for a short time
only
• There are bends or kinks in the
air exhaust hose
• Something is preventing the
air from being discharged
• Position the air hose correctly,
keeping it as short and free of
curves as possible to avoid
bottlenecks
• Check and remove any
obstacles obstructing air dis-
charge
The air conditioner
works, but does not
cool the room
• Windows, doors and/or
and/or curtains are open
• There are heat sources in the
room (oven, hairdryer, etc.)
•The air exhaust hose is deta-
ched from the appliance
• Dust filter and (when present)
silver ion filter and 3M® filter
clogged
• The technical specification of
the appliance is not adequa-
te for the room in which it is
located
• Close doors, windows and
curtains, bearing in mind the
"tips for correct use" stated on
pg. 15
• Eliminate the heat sources
• Fit the air exhaust hose in the
housing at the back of the
appliance (fig. 1)
• Clean the filters as described
in the "Cleaning" section (pg.
16)
During operation,
there is an unplea-
sant smell in the
room
• Dust filter and (when present)
silver ion filter and 3M® filter
clogged
• Clean the filters as described
in the "Cleaning" section (pg.
16)
The air conditioner
does not operate for
about three minutes
after restarting it
• The internal compressor safety
device prevents the applian-
ce from being restarted until
three minutes have elapsed
since it was last turned off
• Wait. This delay is part of nor-
mal operation
The symbol
and
one of the following
messages appears
on the appliance dis-
play:
LT
/
PF
/
HL
/
CL
• The appliance has a self dia-
gnosis system to identify a
number of malfunctions
•See the SELF-DIAGNOSIS sec-
tion (pg.14)