DeLonghi PAC03 Owner Manual - Page 7

Setting up AIR CONDITIONING WITH INSTALLATION Pinguino can also be semi-permanently installed L. f4p1146 inch. 14 TN 20 inch. PP . 12 inc.J, To install, proceed as follows: • Make a hole in a wall communicating with the outside or through the pane of a window. Respect the height and dimensions given in figures E and F. TC1 rl•• • In a window pane in the wood sty of O winciow in the wall: for optimum results. irisulato the section of the wall with suitable insulating material. • Fit the flange 15 1 supplied to the hole. • Fix the tube 116 to the coupling on the back of the unit (figure A, page 6). • Attach the end of the tube to the flan- ge 11i1as shown In the figure. riA When the tube is not attached, close the hole with the bung on the flange 151. NOTE: When the unit is installed semi-permanently, we recommend leaving a door slightly open (1 cm Is enough) to ensure an adequate exchange of air. DEHUMIDIFICATION ONLY Position the appliance in the room without inserting the tube: in this way the dehumidified air will exhaust directly into the room. REMOVING COLLECTED WATER Condensation will be collected in the removable tank 9 It's also possibe to drain it contInuosly. CONTINUOUS EXTERNAL DRAINING Ii the appliance is to be operated for long periods of time but you are unable to empty the tank, you are recommended to use the continuous drain facility. 1) Remove the rubber bung from the spout 2) To fit the rubber hose to the spout, 3) Make sure the hose is on the level otherwise the water will remain in the tank. Check there are no kinks in the hose, N.B:Keep the rubber bung. You will need it to plug the hose or close the spout if you revert to draining into the tank (see point A), The unit must only be used with the air outlet tube 16 provided. Failure to observe the set up and use procedures specified in this manudl absolves the manufacturer from all liability. 7