DeLonghi PAC03 Owner Manual - Page 9

Selecting functions I AS MR CONDITIONER With the unit turned oft, the function selector 12 is in the "Cr position_ To turn the unit on in air conditioning mode, proceed as follows; 1. Potato the function selector knob clockwi- se: # Place the large crystal symbol * in line with the reference mark to operate the unit in air conditioning mode at maximum fan speed. ▪ Place the small crystal symbol * in line with the reference mark to operate the unit in air conditioning mode at minimum fan speed. 2. Now set the required temperature by ratcrting the room thermostat knob. Note The temperature is not expressed in degrees. We therefore recommend rotating the roam thermostat knob 14 to the maximum coal position. When room temperature has reached the required level, rotate the' thermostat knob slowly clockwise until the thermostat is activated, turning the unit off. This programs the unit to the precise level of comfort required which will then be automatically maintained by the thermostat with considerable energy savings. When regulating the thermostat, the air conditioning function is temporarily interrupted and the unit continues to operate in fan only mode. HOW TO DEHUMIDIFY When the appliance is working as an air conditioner. it automatically reduces the excess humidity in the air present in the room, This is eliminated through the exhaust tube 18 „ If only the elimination of the excess humidity in the room is desired without lowering the temperature, simply turn the function selector knob in a clockwise direction until the symbol is reached. The excess condensed humidity automatically gathers in the tank It is also possible to carry out continuous drainage of the condensed humidity, following the instructions on page 7. Note CD in the dehumidifying mode, air colder than the room temperature will exhaust from the air exhaust grill. Conversely, air warmer than room temperature will be exhausted from the Ti accommodation tube on the back side of the appliance. AIR PURIFICATION (FAN ONLY) your air conditioning unit has two special high efficiency electrostatic 3M FJLTRETETM filters. These filters. active in all modes, filter out extremely tine particles (down to 0.01 thou- sands of ❑n inch). If you want to purify the air by ventilating the room only, rotate the function selector 121 counter-clockwise. • Place the large symbol in line with the reference mark to ❑perate the unit in air puri- fication mode at maximum ton speed. • Place the small symbol in line with the reference mark to operate the unit in air purl- 15cation mode at minimum fan speed. TO TURN THE UNIT OFF CpMPLETELY, SET THE FUNCTION SELECTOR 12 TO THE "0" POSITION AND UNPLUG FROM THE SOCKET. THIS UNIT EMPLOYS AN EXCLUSiVE CONDENSATION RECYCLING SYSTEM TO DISPO- SE OF EXCESS MOIST0RE. IN NORMAL CONDITIONS, CONDENSATION IS DISPOSED OF AUTOMATICALLY. WHEN THE HUMIDITY IS PARTICULARLY HIGH. AN EXCESS OF CONDENSATION MAY BUILD UP IN THE TANK WHEN THIS HAPPENS, THE INDICATOR LIGHT Af 13, COMES ON INDICATING THAT THE TANK SHOULD BE EMPTIED. MAKE SURE THE TANK IS PUT BACK CORRECTLY OTHERWISE THE LIGHT 113 WILL REMAIN ON. 4