Dell 8 Fabric OS Command Reference Manual Supporting Fabric - Page 914

2 snmpConfig --show, --set, and --default support the following arguments: snmpv1 Selects SNMPv1-related configuration parameters. These parameters include the community string, trap recipient IP address, and trap severity level associated with each trap recipient IP address. When "0" is configured as a trap port, traps can be received at the default port 162. snmpv3 Selects SNMPv3-related configuration parameters. These parameters include the user name, authentication protocol and password, the privacy protocol and password, the SNMPv3 trap recipient's IP address, its associated user index and trap severity level. When "0" is configured as a trap port, traps can be received at the default port 162. In Fabric OS 6.3.0 and later, the --set snmpv3 command supports an interactive option to enable or disable informs by setting the parameter "SNMP Informs Enabled" to true or false. If informs are enabled, all trap destinations receive inform requests. If informs are disabled, all trap destinations receive trap requests. When informs are enabled, the engine ID must be set to correspond to the management engine IP address (see example). Informs are by default disabled. IPv6 Informs are currently not supported. accessControl Selects access-control-related parameters. These parameters include the access host subnet area and access permission (read-write). mibCapability Selects configuration parameters related to the SNMP agent's MIBs and trap capability parameters. These parameters include MIBs and traps supported by the SNMP agent. systemGroup Selects configuration parameters related to the system group. These parameters include sysDescr, sysLocation, sysContact, and authentication failure trap. secLevel Sets the SNMP security level. SNMPv1 Configuration Parameters The agent supports six communities and their associated trap recipients and trap recipient severity levels. The first three communities are for read-write (rw) access and the last three are for read-only (ro) access. The default value for the trap recipient of each community is 0.0.0.0. The length of the community string should be in the range of 2 to 16 characters. The default values for the community strings are: Community 1: Secret Code Community 2: OrigEquipMfr Community 3: private Community 4: public Community 5: common Community 6: FibreChannel When an FCS policy s enabled, community strings can be changed on the primary FCS switch only, and only the primary FCS switch propagates changes across the fabric. 882 Fabric OS Command Reference 53-1001764-02