Dell DR2000v DR Series System Administrator Guide - Page 29
Adding a DR Series Hardware System Expansion Shelf, Not Con d
View all Dell DR2000v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Figure 5. SAS Port and Cable Connections (Dell PowerVault MD1200 EMM) 1. SAS cable 2. pull-tab Adding a DR Series Hardware System Expansion Shelf To set up, add, and connect an expansion shelf correctly to a DR Series hardware system appliance, you need to complete the following tasks. • Power off the DR Series system. • Install all cabling that connects the external expansion shelf (or shelves) to the DR Series system (For information, see the topic, DR Series System - Expansion Shelf Cabling). • Power on the external expansion shelf (or shelves), and then power on the DR Series system. • Install the Dell license for expansion shelf enclosures (for information, see the topic, Installing an Expansion Shelf License). • In the DR Series system GUI, add and activate the expansion shelf enclosure on the Storage page (as described in the steps below). To add an expansion shelf to the DR Series system, complete the following steps: 1. Click Storage in the navigation panel. The Storage page is displayed. (This step assumes that you have completed all expansion shelf enclosure cable connections and that green LEDs are displayed next to the fastplugs on the rear chassis, indicating that cable connections are active.) 2. In the Physical Storage pane, click Add in the Configured column of the Physical Storage summary table that corresponds to the enclosure you want to add (Not Configured is the displayed State for the enclosure). The Enclosure Addition dialog is displayed that indicates that all input-output to the system will be stopped during an enclosure addition, and prompts you to click OK to continue or click Cancel to stop this process. 3. Click OK to continue adding the enclosure to the DR Series system. 4. If you clicked OK, an Enclosure Addition dialog box is displayed that indicates this process may take up to 10 minutes to complete. A System Status dialog then displays with the following message: The system is currently adding an enclosure. Please wait for this process to complete and the system to become operational. 29