Dell EqualLogic PS6610ES EqualLogic PS6610 Storage Arrays Hardware Owners Manu - Page 29

Install, Control, Module

Get Dell EqualLogic PS6610ES PDF manuals and user guides View all Dell EqualLogic PS6610ES manuals
Add to My Manuals
Save this manual to your list of manuals

Page 29 highlights

PS6610 Hardware Owner's Manual 3 Control Module Maintenance Figure 14: Removing a Control Module 3. Place the control module on a flat surface where it will be protected from electrostatic discharge. To avoid damage, do not place anything on top of the control module. 4. If you are replacing a failed control module, remove the microSD card from the failed control module and install it in the replacement control module. Using the card from the failed control module ensures that the new control module is running the correct firmware and a correct array configuration. See Replace the MicroSD Card on page 25. Return the failed control module in the packaging in which the replacement module was shipped. Contact your PS Series support provider for information about returning hardware. Install a Control Module You can install a control module without shutting down the array. Caution: Replace control modules with the same type only. Do not mix control module types in an array. Control modules are installed horizontally in the array, with the Ethernet ports on the right and the serial port on the left. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
PS6610
Hardware
Owner's
Manual
3
Control
Module
Maintenance
Figure
14:
Removing
a
Control
Module
3.
Place
the
control
module
on
a
flat
surface
where
it
will
be
protected
from
electrostatic
discharge.
To
avoid
damage,
do
not
place
anything
on
top
of
the
control
module.
4.
If
you
are
replacing
a
failed
control
module,
remove
the
microSD
card
from
the
failed
control
module
and
install
it
in
the
replacement
control
module.
Using
the
card
from
the
failed
control
module
ensures
that
the
new
control
module
is
running
the
correct
firmware
and
a
correct
array
configuration.
See
Replace
the
MicroSD
Card
on
page
25
.
Return
the
failed
control
module
in
the
packaging
in
which
the
replacement
module
was
shipped.
Contact
your
PS
Series
support
provider
for
information
about
returning
hardware.
Install
a
Control
Module
You
can
install
a
control
module
without
shutting
down
the
array.
Caution:
Replace
control
modules
with
the
same
type
only.
Do
not
mix
control
module
types
in
an
array.
Control
modules
are
installed
horizontally
in
the
array,
with
the
Ethernet
ports
on
the
right
and
the
serial
port
on
the
left.
23