Dell Inspiron 560 Service Manual - Page 19

Optical Drive

Get Dell Inspiron 560 PDF manuals and user guides View all Dell Inspiron 560 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

3. Gently slide the Media Card Reader into place in the FlexBay slot. 4. Align the screw holes in the Media Card Reader with the screw holes in the drive panel. 5. Replace the two screws that secure the Media Card Reader to the drive panel. NOTE: Ensure that the Media Card Reader is installed before the FlexBay USB cable is connected. 6. Connect the FlexBay USB cable to the system board connector (see System Board Components). 7. Replace the front bezel (see Replacing the Front Bezel). 8. Replace the computer cover (see Replacing the Computer Cover). 9. Connect your computer and devices to electrical outlets, and then turn them on. Optical Drive Removing the Optical Drive 1. Follow the procedures in Before You Begin. 2. Remove the computer cover (see Removing the Computer Cover). 3. Remove the front bezel (see Removing the Front Bezel). 4. Disconnect the power cable and the data cable from the back of the optical drive. NOTE: If you are not replacing the optical drive at this time, disconnect the other end of the data cable from the system board and set it aside. You can use the data cable to install an optical drive at a later time. 5. Remove the two screws that secure the optical drive to the drive panel. 6. Slide the optical drive out through the front of the computer.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
3.
Gently slide the Media Card Reader into place in the FlexBay slot.
4.
Align the screw holes in the Media Card Reader with the screw holes in the drive panel.
5.
Replace the two screws that secure the Media Card Reader to the drive panel.
6.
Connect the FlexBay USB cable to the system board connector (see
System Board Components
).
7.
Replace the front bezel (see
Replacing the Front Bezel
).
8.
Replace the computer cover (see
Replacing the Computer Cover
).
9.
Connect your computer and devices to electrical outlets, and then turn them on.
Optical Drive
Removing the Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove the front bezel (see
Removing the Front Bezel
).
4.
Disconnect the power cable and the data cable from the back of the optical drive.
5.
Remove the two screws that secure the optical drive to the drive panel.
6.
Slide the optical drive out through the front of the computer.
NOTE:
Ensure that the Media Card Reader is installed before the FlexBay USB cable is connected.
NOTE:
If you are not replacing the optical drive at this time, disconnect the other end of the data cable from the system board and set it aside.
You can use the data cable to install an optical drive at a later time.