Dell Inspiron 6000 Service Manual - Page 41

Back to Contents Page Memory Module and Modem Dell Inspiron™ 6000 Service Manual Memory Module Modem Memory Module Removing a Memory Module CAUTION: Before you perform the following procedures, see the safety instructions in the Product Information Guide. CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface. NOTICE: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a component such as a microprocessor by its edges, not by its pins. NOTE: Memory modules purchased from Dell are covered under your computer warranty. NOTE: To get maximum performance\dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and the modules must be of the same size and configuration. 1. Follow the instructions in "Preparing to Work Inside the Computer." 2. Turn the computer over, loosen the two captive screws from the memory module cover, and remove the cover. NOTICE: To prevent damage to the memory module connector, use your fingers instead of a tool to spread the clips that secure the memory module. 3. If you are replacing a memory module, remove the existing module. NOTICE: Handle memory modules by their edges, and do not touch the components on a module. a. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up. b. Remove the module from the connector at a 45-degree angle. Replacing a Memory Module